AIRTRONICS VG6000 Especificações descarregar pdf (Página 6)

Page 6

VG6000

Ch 6 Flap

Ch 5 Gear

Ch 4 Rudder

Ch 3 Throttle

Ch 2 Aileron

Ch 1 Elevator

The above diagram shows how to connect the components of your VG6000 system together. At this point

your objective is to get the system operating on your workbench. Once connected you must then refer to

the corresponding diagram for your system showing the transmitter control stick function.

NiCd BATTERY CHARGING INFORMATION:

In order to protect the charging circuit in your VG6000 transmitter, a diode has been installed to protect it

from some of the high discharge rate “cycler’s” on the market. We recommend that you charge the

transmitter battery (while installed) with the supplied ATX charger, Part # 95033Z.

Should you wish to “cycle” or discharge the transmitter battery, you must first remove it from the transmit-

ter. This allows you to bypass the protective diode.

The following two Airtronics service items will allow you to “cycle” your VG6000 transmitter battery. See

your local dealer for these items.

(1) #99704 Transmitter Charging Plug with Cable for use with your cycling device (black wire w/white

tracer is positive.

(1) #97051 Transmitter Battery Cycling Adapter Cable.

Above items will also work with Airtronics Quasar, Radiant, Vanguard, VG Series and all RD Series

transmitter batteries.

AIRBORNE SYSTEM CONNECTIONS

7/B

92777/72 FM

BAN D

Dual Conversion

Narrow Band Receiver

NiCd Battery

Charge

Connector

92777Z Receiver

Switch Harness

1 2 3 4 5 6 7 8 9 10 11 ... 22 23

Sem comentários

AIRTRONICS VG6000 Especificações Página 6