Page 4
l
The antenna wire is delicate. Handle with care. Do not pull on the antenna wire with force.
l
Do not cut or extend the antenna wire.
l
The antenna wire should be installed into a vertical plastic tube per your particular model's
assembly instructions. Keep the receiver antenna as far away from the motor, battery, and
electronic speed control as possible.
l
There is a danger of runaway operation if connectors shake loose during use. Make sure that the receiver,
servo(s), and switch connectors are securely tted.
l
The receiver is susceptible to vibration, shock, and moisture. Take appropriate measures
to protect against vibration and moisture. Failure to take appropriate measures could
result in runaway operation or damage to the receiver. We suggest wrapping the
receiver in shock-absorbing foam rubber when installing it into your model.
l
When installing the receiver, avoid contact with any carbon or metal chassis components.
l
Contact between metal parts mounted on a model can result in electrical noise, which
can adversely effect receiver performance and possibly result in runaway operation or
damage to your model.
l
With electric-powered models, be sure to t the motor with a noise suppression capacitor.
Without a noise suppression capacitor, excessive electrical noise generation can cause
runaway operation and/or result in damage to your model.
l
Use rubber anti-vibration absorbers with servos. Direct transmission of engine vibration to servos can cause
servo failure and possibly result in runaway operation with damage to your model.
l
The receiver does not feature BEC circuitry. If using an electronic speed control, verify that it features BEC
circuitry to drop the receiver voltage between 4.8v~6.0v.
l
Turn the transmitter ON rst and then turn the receiver ON. After using your model, turn
the receiver OFF rst, then turn the transmitter OFF. It can be dangerous if you activate
the components in reverse order as the servos may start up inadvertently.
l
Before use, double-check that the transmitter and receiver batteries have
sufcient power.
l
Never touch the transmitter antenna during use. Doing so may cause a reduction of transmitter
output, resulting in a loss of signal.
l
Do not bend the antenna or damage could result.
l
During use, the transmitter should be held so that the antenna is vertical at all times.
l
Do not expose the transmitter or any other components to excessive heat, moisture, fuel,
exhaust residue, etc.
l
Do not press the Bind Button during use. The signal is interrupted while the Bind Button is
pressed. It may also require a short time to restore the signal after releasing the Bind Button, which can be dangerous.
l
If the outer case becomes dirty, it can be cleaned with a soft dry cloth. If the outer case becomes soiled, it can
be cleaned with a damp cloth and liquid detergent.
l
Do not use any solvents to clean the outer case. Solvents will damage the nish.
Antenna Tube
Antenna Wire
l
If the 2.4GHz frequency band is saturated (too many transmitters on at once), as a safety precaution, the radio
control system may not bind. This ensures that your radio control system does not get hit by interference. Once
the frequencies have been cleared, or the saturation level has dropped, your radio control system should be able
to bind without any problems.
(116 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais