AIRTRONICS MT-4s Guia do Utilizador descarregar pdf (Página 48)



T R

Starting and Stopping the Telemetry Log:

The Telemetry Log function must be Started in order for the transmitter to read and store Telemetry Data from the receiver.

1) In the default configuration, Push-Button Switch Sw1 controls the Telemetry Log. To start the Telemetry Log, press the

Push-Button switch. LED1 (Blue) will flash, indicating the Telemetry Log is storing data. Telemetry Data is stored for all four

Telemetry functions, whether the Telemetry Sensors are hooked up or not.

2) To stop the Telemetry Log, press the Push-Button Switch a second time. If desired, the Telemetry Log Function can be

assigned to Push-Button Switch Sw2. For more information, see the Key Assignments section on pages 53 through 58.

Each time the Telemetry Log is started, any old Telemetry Data is automatically erased. In addition, the Telemetry Log will

stop automatically once the Telemetry Log is filled. The Telemetry Log can store 120 separate entries. If the Log Interval

is set to 00.1 seconds, the Telemetry Log can record for 12 seconds. If the Log Interval is set to 45.1 seconds, the Telemetry Log

can record for 90 minutes. To change the Log Interval value, see the Changing the Telemetry Log Step Value section on page 68.

Viewing Telemetry Data:

1) From the Top Screen, press the ENTER key to open the Programming Menu list.

2) Scroll UP or DOWN to highlight the LOGGER menu, then press the ENTER key. The

LOGGER menu will be displayed and TEMP1 DATA will be highlighted.

3) From within the LOGGER menu, scroll UP or DOWN to highlight the desired Telemetry

Data you would like to view. Choose from TEMP1 DATA, TEMP2 DATA, VOLT DATA or

RPM DATA.

4) Press the ENTER key to open the Telemetry Log.

5) To view the Telemetry Data at a specific point along the graph, scroll UP or DOWN to

move the vertical line right or left. The Telemetry Data for each point the vertical line is at

is displayed at the bottom of the screen.

6) To view all of the Telemetry Data points, press the ENTER key to open the Telemetry

Data List, then scroll DOWN to view all of the recorded Telemetry Data entries.

The Telemetry Log can be started and stopped while viewing Telemetry Data. To start the Telemetry Log, press and HOLD

the ENTER key and to stop the Telemetry Log, press and HOLD the ENTER key a second time.











For information about using an optional Telemetry receiver with your MT-4S transmitter and installing Telemetry Sensors

into your model, see the Telemetry Connections and Mounting section on pages 69 and 70. In addition, to be able to read

and log Telemetry Data, the Telemetry system must be turned ON. For more information about turning the Telemetry system

ON, see the Telemetry Setting section on pages 67 and 68.

IMPORTANT: Full telemetry support requires the use of an Airtronics 2.4GHz FH4T telemetry-capable surface receiver, such

as the RX-461 or RX-462, along with Airtronics Temperature and RPM Sensors (available separately). The included RX-472

receiver can send Telemetry Data for the voltage of the receiver battery pack only, unless used with the Airtronics Super

Vortex ZERO ESC (available separately) plugged into the BATT/SSL port of the included RX-472 receiver.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 87 88

Sem comentários

AIRTRONICS MT-4s Guia do Utilizador Página 48